The BTD (Buy the Dip) bot is Bitsgap’s simplest automated strategy. It does one thing: waits for a configured price drop, executes a buy, and holds for a take-profit. No grid levels, no safety order ladders — just structured dip-buying with a defined exit. Here’s how to configure it and when it makes sense.
Try it free
Bitsgap
Run GRID, DCA, COMBO, and BTD bots across 15+ exchanges from one dashboard. 7-day free trial, no card needed.
How the BTD Bot Works
The BTD bot operates on a simple trigger:
- Monitor price: The bot watches the configured trading pair continuously
- Detect dip: When price drops by your configured percentage from a recent high (or from the current price at bot launch), the trigger fires
- Execute buy: A market or limit buy order executes at the dip level
- Hold for take-profit: The bot holds the position and exits when price rises to your take-profit target
- Reset: After the take-profit closes, the bot resets and starts monitoring again
The BTD bot is a directional, single-trade strategy. You’re betting that the dip is temporary and that the asset will recover. If the asset continues declining, the bot holds a losing position until the stop-loss fires or the market recovers.
When to Use the BTD Bot
Good conditions:
- Asset has consistent short-term dip-and-recover behavior (BTC and ETH in uptrends or consolidations)
- You have medium-term bullish conviction on the asset
- Market has a clear support level below current price
Poor conditions:
- Sustained downtrend: The bot buys the dip, the dip continues, the take-profit never hits
- Extreme volatility without recovery: Dip triggers keep firing, positions accumulate losses
- Thinly traded altcoins: Sharp dips often don’t recover cleanly
BTD vs DCA Bot: Key Differences
| Feature | BTD Bot | DCA Bot |
|---|---|---|
| Number of buys | Single buy per cycle | Multiple buys (base + safety orders) |
| Entry logic | Single dip trigger | Base order + stacked safety orders |
| Averaging | No | Yes (blended average entry) |
| Capital per cycle | Fixed single amount | Scales with number of safety orders |
| Take-profit | Fixed % above entry | Fixed % above blended average |
| Complexity | Low | Medium |
| Best for | Clean dip/recover cycles | Deep dip recovery with averaging |
Use BTD for shallower, shorter dips where a single entry is sufficient. Use DCA for deeper or extended dips where averaging down across multiple levels improves your entry price.
Configuration Guide
Step 1: Select Trading Pair and Exchange
Go to Bots → BTD Bot → Create New Bot. Select your exchange and trading pair. BTC/USDT or ETH/USDT are the most common BTD bot pairs due to consistent dip-and-recover behavior.
Step 2: Set the Dip Trigger
The dip trigger is the percentage drop from a reference price that activates the buy order.
Options:
- From bot start price: The dip is measured from the price at the moment you launch the bot
- From rolling high: The dip is measured from the highest price seen since the bot launched (more dynamic)
Configuration considerations:
- 3–5% dip: Frequent triggers, small individual dips, more cycles per month
- 7–10% dip: Less frequent, captures more meaningful dips, fewer but potentially higher-quality entries
- 15%+ dip: Rare triggers, major corrections only
BTC historically dips 3–8% multiple times per month during consolidations. A 5% trigger on BTC/USDT typically fires 4–8 times per month in normal market conditions.
Step 3: Set Buy Order Size
The dollar amount deployed per BTD cycle. Keep individual cycle sizes reasonable relative to your total account — if you’re running 5 BTD bots simultaneously, $200 per bot at 5% dips with $5,000 total is a 20% per-cycle deployment.
Step 4: Set Take-Profit
Percentage above your buy price at which the bot sells. Common settings:
- 1.5–2%: Fast cycles, low profit per trade
- 3–5%: Moderate cycles, good risk/reward balance
- 8–12%: Patient approach, fewer cycles but larger gains per trade
Your take-profit must exceed round-trip trading fees. At 0.1% per trade (0.2% total), a 1.5% take-profit nets approximately 1.3%.
Step 5: Set Stop-Loss
Set a stop-loss at 5–8% below your buy entry. This closes the position if the dip continues instead of recovering, capping your downside per cycle.
Step 6: Optional Trailing Stop-Loss
On Advanced and Pro plans, you can enable a trailing stop-loss that follows price up. Instead of a fixed exit at your take-profit price, the bot follows price up and sells when price reverses by a configured percentage — capturing extended moves beyond the initial target.
Practical BTD Bot Setup for BTC
Based on BTC’s historical behavior in 2025–2026:
- Pair: BTC/USDT
- Exchange: Binance or Coinbase Advanced
- Dip trigger: 5% from rolling high
- Buy size: $300 per cycle
- Take-profit: 3%
- Stop-loss: 7% below entry
- Order type: Market
Expected behavior: Triggers several times per month during normal volatility. Each successful cycle nets approximately $9 (3% on $300 minus fees). If BTC drops 7%, the bot stops out at roughly -$21 plus fees.
This isn’t a wealth-building machine — it’s a systematic way to trade dips with defined risk parameters rather than manual, emotional decision-making.
Running Multiple BTD Bots
Since BTD bots are simple and capital-efficient (fixed buy size, no safety order ladder), you can run multiple simultaneously on different pairs. Basic plan allows running BTD bots alongside up to 3 GRID bots and 10 DCA bots.
Diversifying BTD bots across BTC, ETH, and one or two conviction altcoins spreads cycle frequency and reduces dependence on a single pair’s behavior.
For the GRID bot alternative, see How to Use Bitsgap GRID Bot 2026. For combined strategies, see Bitsgap for Passive Income 2026.
Why Bitsgap Pairs with Coinbase Advanced
BTD bots on BTC/USD via Coinbase Advanced give US traders a straightforward automated dip-buying strategy on a fully regulated exchange. Connect Coinbase Advanced to Bitsgap in minutes.
Recommended exchange
Coinbase Advanced
Up to 3.85% USDC rewards on trading balance, low maker/taker fees, and full Coinbase Advanced toolset.
Get Real-Time BTC Signals
Use the AI-powered BTC signal tool before setting BTD bot triggers. If the predictor shows high confidence in near-term downside, consider waiting before launching. If it shows range-bound behavior, BTD bots are well-positioned.
FAQ
How is the BTD bot different from a simple limit order?
A limit order executes once and doesn’t reset. The BTD bot automatically resets and re-enters after each completed cycle, running indefinitely without manual intervention.
Can the BTD bot lose money?
Yes. If the asset drops significantly and doesn’t recover before the stop-loss, the bot closes at a loss. Sustained downtrends are the main risk.
What’s the minimum investment for a BTD bot?
The buy size must meet your exchange’s minimum order value (typically $10–$20). Practically, $100–$500 per BTD bot cycle is a reasonable range.
How many BTD bots can I run on Basic plan?
Bitsgap doesn’t list BTD bots as a separate counter from other bot types on the Basic plan — they count toward your total active bot allowance. Check current limits in your Bitsgap dashboard.
Is the BTD bot available on all Bitsgap plans?
Yes, including Basic at $29/mo.
Related on NeuralMindMastery
- How to Use Bitsgap DCA Bot 2026
- Bitsgap COMBO Bot Explained 2026
- Bitsgap for Beginners 2026
- Bitcoin Bottom Prediction 2026
Bitsgap performance varies by market conditions. Past results don’t guarantee future returns. This is not financial advice.